Continuing to invest in our people – CMM Training
Jenks & Cattell Engineering would like to offer our congratulations to Pav, Ryan and Jack, who spent 2 days at our preferred CMM training supplier QCT.
Both Kevan, our Engineering Manager and Craig, Technical Director, presented them with their certificates of competency, in the use of our valuable co-ordinate measuring machine.
All three of our guys said during the presentation, that they found the training to be “very well worth while”, and told us that they insisted on the second day; they requested to the trainer that they wanted to start the programming side of the course, which normally takes place on the fourth day.
The two-day off site course allowed the three guys to bond further during the ‘out of hours’ time they spent together, which is terrific for moral within our engineering department.
Craig said during the presentation;
“ You guys are the bed rock of our future, and both Kevan and I are proud to support you, in expanding your talent that you show and share, towards Jenks and Cattell Engineering.
Since this training, all three guys been using our CMM machine, carrying out various measurements on project parts they are looking after, therefore proof that we have given them all the confidence to operate a machine, that is worth over £50,000!”
Kevan stated “The Directors and Management at Jenks & Cattell are always willing to provide fiscal backing to develop our people with training, and shall continue to do so”.
Our CMM machine is a key part of our quality department, and allows all of our customers parts to be measured to CAD.